Assembly instruction vacuum cleaner



... to Part 2, Part3,Modernization


WARNING:
This vacuum cleaner is experimental version!
Vacuum cleaner can work only on the floor without steps and decorative coatings.

List of required parts:

  1.  1PCS - SPP-C Bluetooth serial pass-through module wireless serial communication from machine Wireless SPPC Replace HC-05 HC-06
  2.    6PCS -          IR Infrared Obstacle Avoidance Sensor Module for Arduino Smart Car Robot 3-wire Reflective Photoelectric                                                                                   
  3.  2PCS -        N20 DC12V 100RPM Gear Motor 3mm Shaft Diameter                          
  4.  8PCS -       10*2mm N50  Powerful  Neodymium Disc Magnets 
  5.  2PCS -    DIY Black Storage Box Holder Case For 3 x 18650 3.7V                        
  6.  2PCS -  0-24V Top Mosfet  IRF520 MOS Driver Module  
  7.  1PCS - 3A 5.5x2.1mm DC Power Sock Jack Female Connector                       
  8.   1PCS - Pro Mini Atmega168 5V 16M For Arduino Nano Module                      
  9.  2PCS - HC-020K Double Speed Measuring Module with Photoelectric Encoder 
  10.  2PCS - 1:48 Remote Car Robot Gears Driver Motor 
  11. 1PCS -  DC Stepper Motor Drive Controller Board Module L298N   
  12.   1PCS - 3S 3 Series Lithium Battery Capacity Indicator Module 12.6V  
  13.   1PCS -  3S 20A Li-ion Battery 18650 Charger 12.6V Cell 64x20x3.4mm  PCB BMS Protection Boards Modules 
  14.  2PCS - 3D Printer RAMPS 1.4 End Stop Limit Switch Module 
  15.  1PCS - XL6009 DC Step up boost Power Converter Module LM2577 
  16. 2PCS - DC Step Down Converter Module LM2596 DC 4.0~40 to 1.3-37V 
  17. 1PCS - PWM blower server dedicated turbofan 9733 97x97x33mm 9.7cm 12V fan 
  18.  Many :) PCS - Cable 20-30-40cm 2.54mm 1pin  Female to Male, Male to Male, Female to Female jumper wire for Arduino 
  19.  6PCS -  Li-ion 2600 - 3000mAh 18650 rechargeable battery ( batteries must be good quality! The best variant- 30A!!! ) 
  20.  1PCS -  12.6V charger for CCTV battery pack,3A  lithium battery 12V 
  21.  1,5kg -  3D Printer PETG Filament 1,75/3.0  
  22.  1PCS -  Switch 15 x 21 mm.  
                                                                                                                                                      
... to Part 2, Part3,Modernization

                         










             






      Comments

      1. ruslanzel21 December 2021 at 13:11

        Hello. Thanks You for interested about this project...🤗🙂

        ReplyDelete
      2. Asrul Yanuar1 November 2022 at 04:09

        Thanks for sharing. Awesome project. Good Luck for you. I am teacher. this tutorial is great. thanks a lot

        ReplyDelete

      Post a Comment